Replaced my ignition coil
Thread Starter
Joined: Jun 2006
Posts: 1,699
Likes: 17
From: Southern California
Car: 1987 Camaro LT
Engine: LG4 w/ SLP headers & a 3" catback
Transmission: THM700R4 (Stock)
Axle/Gears: Stock 2.73 gears. No Posi
Replaced my ignition coil
The Hypertech one I had failed. Installed a new BWD Select brand remote coil. Car started up on the first turn. And made in the U.S.A. 
Last edited by MY87LT; Mar 4, 2014 at 09:43 AM.
Thread Starter
Joined: Jun 2006
Posts: 1,699
Likes: 17
From: Southern California
Car: 1987 Camaro LT
Engine: LG4 w/ SLP headers & a 3" catback
Transmission: THM700R4 (Stock)
Axle/Gears: Stock 2.73 gears. No Posi
Re: Replaced my ignition coil
Forgot to add that I did install a BWD ignition module as well. I didn't use the supplied grease that you are supposed to used under the module. Instead I read on here to use the high temperature heat compound they sell at Radio Shack. It's a silver compound and the tube is really small. Set me back like $14 bucks or so. Hope it's as good as they say it is.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM