No Injector Pulse
Thread Starter
Senior Member
Joined: May 2011
Posts: 549
Likes: 1
From: Houston,Texas
Car: 1992 Camaro (Z28 Clone)
Engine: LB9|TPI
Transmission: 700R4
Axle/Gears: 2.73
No Injector Pulse
Hey guys I have a 1992 Camaro RS with a 305 that I am currently swapping to TPI from a Carb setup that the previous owner had installed on it.
I have everything wired up and installed but I can not get it to run.
I have checked everything and i have tracked it down to no injector pulse.
Every sensor on the car with the exception of the IAC is new.
It has a new Alternator, starter, battery, fuel pump and sending unit, distributor,wires, plugs, and injectors.
any help from you guys will be greatly appreciated.
Thanks!
I have everything wired up and installed but I can not get it to run.
I have checked everything and i have tracked it down to no injector pulse.
Every sensor on the car with the exception of the IAC is new.
It has a new Alternator, starter, battery, fuel pump and sending unit, distributor,wires, plugs, and injectors.
any help from you guys will be greatly appreciated.
Thanks!
Supreme Member
Joined: Apr 2006
Posts: 4,482
Likes: 10
From: Northern, CA
Car: 1989 Iroc-Z Camaro
Engine: TBI,5.0
Transmission: Automatic 700R4
Axle/Gears: Eaton Posi,3.42,LPW Ultimate Cover
Re: No Injector Pulse
I believe the ECM/EPROM requires a VATS signal.
This might help = https://www.thirdgen.org/forums/elec...ing-tuned.html
This might help = https://www.thirdgen.org/forums/elec...ing-tuned.html
Last edited by Ron U.S.M.C.; Mar 4, 2015 at 08:41 PM.
Thread
Thread Starter
Forum
Replies
Last Post