When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am finishing up my Holley Terminator X install on my 89 GTA, I am down to C207, I am trying to figure out what wires are needed. I would like to use the injector power to power up the 3.5" screen and also tap into the remaining red wire from the terminator.
I have been trying to match up the wires on this connector. I have found information on this site and it doesn't seem to match up. The tan and white wire runs to my alternator which I have been looking to see what it does, but I am not finding the right pin out. This car previously had an Accel DFI system on it, and I am not sure what was messed with.
Last edited by 17RamGTA; May 25, 2022 at 10:03 AM.
