Fresh 350 with Vortec heads.
02-14-2007, 01:26 PM
#1
Fresh 350 with Vortec heads.
Heads: 350 Vortec heads. Machine shop went throught them with new valve stem seal, and swirl polished valves.
Block
1978 350 4-bolt main 010 block
.060 over zero decked
clearanced for 383 stroker
New hyper 4-valve releif flattop pistons
chromemoly rings
GM 3.48 stroke crank
GM vortec 5.7 rods
New Double row timing chain
HV melling oil pump
clevite rod/main bearings
New 292h 501/501 flattappet cam/lifters
oil pan
timing cover
balancer
flexplate
Zero miles on this fresh motor.
Located in London Kentucky zip 40741. Right off Interstate 75
Asking $1400 obo
Will ship at buyers expense.
Pics of shortblock.
https://www.thirdgen.org/forums/atta...age008_001.jpg
https://www.thirdgen.org/forums/atta...age009_002.jpg
https://www.thirdgen.org/forums/atta...age010_003.jpg
https://www.thirdgen.org/forums/atta...age011_004.jpg
https://www.thirdgen.org/forums/atta...age012_005.jpg
https://www.thirdgen.org/forums/atta...age013_006.jpg
Block
1978 350 4-bolt main 010 block
.060 over zero decked
clearanced for 383 stroker
New hyper 4-valve releif flattop pistons
chromemoly rings
GM 3.48 stroke crank
GM vortec 5.7 rods
New Double row timing chain
HV melling oil pump
clevite rod/main bearings
New 292h 501/501 flattappet cam/lifters
oil pan
timing cover
balancer
flexplate
Zero miles on this fresh motor.
Located in London Kentucky zip 40741. Right off Interstate 75
Asking $1400 obo
Will ship at buyers expense.
Pics of shortblock.
https://www.thirdgen.org/forums/atta...age008_001.jpg
https://www.thirdgen.org/forums/atta...age009_002.jpg
https://www.thirdgen.org/forums/atta...age010_003.jpg
https://www.thirdgen.org/forums/atta...age011_004.jpg
https://www.thirdgen.org/forums/atta...age012_005.jpg
https://www.thirdgen.org/forums/atta...age013_006.jpg
02-15-2007, 11:15 AM
#2
Posting this for a friend.
I did help him with some of the assembly. Everything was done right and to specs. All clearances were checked and double checked. This will be a strong motor for any thirdgen.
We did a light port & polish job on the heads. I can get pics of the heads on the motor if needed.
I did help him with some of the assembly. Everything was done right and to specs. All clearances were checked and double checked. This will be a strong motor for any thirdgen.
We did a light port & polish job on the heads. I can get pics of the heads on the motor if needed.
Thread
Thread Starter
Forum
Replies
Last Post
509 camaro fan
Tech / General Engine
13
09-06-2015 10:43 AM
Eric-86sc
Engine/Drivetrain/Suspension Parts for Sale
0
08-24-2015 09:01 PM
L98GTA87
Engine/Drivetrain/Suspension Wanted
1
08-11-2015 06:55 PM
