Back up for sale is my ford 9" set up by Moser, has all the perches and brackets needed to bolt up including the torque arm bracket, 31 spline axles, 3.9 street gears, locker, 13" HUGE drum brakes on it with parking brake cables, so pretty much throw right in and go. Minimal miles but has been sitting for a while. It's under my car right now and does work perfectly, I drove it right before winter hit. A setup new from moser with a nodular, 3.9, locker center, 31 spline axles, housing and drum brakes, is right under 3 g's. I'm only looking for $1500, just going in a different direction. I will ship it if you pay for the shipping.

 

i would defentialy take that off your hands if i had $1500 on me
would it be possible if you were able to hold onto it for about amonth and a half?? or do you need the money right away?
if you can hold onto it for an extra month and a half ill take it.

 

Prices at Strange are shooting up starting Feb 1st, I would like to get rid of this before then.

 

yeah i figured so.
anyways thanks.
if you still have it by mid feburary ill check into again.

 

ill keep you inmind if I have it then

 

alright thanks.

 

what's involved to loose the rear drums and install the PBR style plates?

 

my guess would be drilling new holes in the backplate of the disc brakes, new housing ends, or just an adaptor.

 

shipping estimate to hilton, ny 14468

 

shipping to phoenixville, pa 19460

 

shipping's going to be 225-300 depending on where you live. It'll be cheaper for surrounding states.

East coast like PA and NY is going to be around 240-260

 

is it the same dimentions as factory

 

yes it is

 

thats a hell of a deal if i didnt have a 12 bolt i would seriously look into that. paid near 3000 for mine. bump for a good deal.

 

If you wait a couple months, I'd buy it. Funds are low at the moment.

 

Does this have stock Ford axles? Aftermarket center section? N Case? Large bearing housing? Stock pinion support? Whose locker?

 

I would be all over this if it was 4th gen length

 

if you are local to the area as well perhaps we could work out a deal leaving the poster with cash= you a 9" = me a 12 bolt

 

what?

 

Sent you an message via AIM. Will wait to hear back from you.

Tim

 

it's been sold for a while now sorry

 

i am in australia and getting here isnt the problem.

It needs to be presure washed and have no grease or mud on it and it would cost 700 to get it to L.A where we ship from.then i nedd to change to 3.25 gears

 

Post is from 2008, mate.

 

my god Time flys..

i thought someone sent it to me...

no wuckin furries.. thanks mate