Hey all, im considering selling my factory tuned port intake since its just sitting on a shelf. The plenum has been ported out and the base has been siameased (sic) over halfway into the ports. I can stick my whole hand in there. It gave my car a noticeable gain over stock. It didnt hit that tpi brick wall at 4800 rpms. It will come with the base, runners, plenum, fuel rails and regulator, water outlet, and distributor cover. Its off an 89 model formula so theres no cold start injector. It uses stock gaskets but you would have to cut the centers out of the base to make them oval shaped. I'm asking $150 obo. I'll get pics of it tomorrow.

 

waiting for pics

 

There are some pics of the intake. There is one stripped bolt hole (the bottom of the three that holds the throttle bracket on) and one that i had a standard bolt in on the drivers side rear runner. The distributor cover comes with it but is not in the pics. Also the base could be ported and siameased even further and i forgot about my DIY adjustable fuel pressure regulator that goes with it.

 

how much shipped to 65251??

 

Back up. Make Offer.

 

If you can do $150 shipped let me know and i can Paypal right away.....

Thanks
Bill

 

PM sent.

 

i'd go 165$ shipped to 43056 and you can keep the rails the egr valve and the water neck if you can get any use out of them as they will just sit considering what i currently would be needing is only a manifold so i dont have downtime porting my current 1 on my car while i do a heads and cam swap.

 

Scott is a good guy and a man of his word..... i will back out and let Flaming have the intake.... good luck with the sale.....

Bill

 

well is it sold? Let me know,I am int. in the complete setup.

 

Sold pending payment.