[FL] Near complete SBC 350 bored.30 over, forged TRW pistons, forged crank
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Dec 2004
Location: Orlando,FL
Posts: 682
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 GTA Trans Am
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: Borg Warner 9-Bolt 3.27
Near complete SBC 350 bored.30 over, forged TRW pistons, forged crank
Finally found a bigger block to put in my GTA so gonna sell the 350. Don't wanna separate beyond the pistons. Heads are off. It's bored .30 over, forged TRW pistons, forged crank, crane cam, hardened push rods, double valve springs, new PRW steel roller rockers 1.5 ratio self aligning, hydraulic roller lifters, stock heads are ported, mallory HV oil punp, new starter. I'm keeping my intake, carb, headers and pulleys for my 400sbc. The block was painted chevy orange
The intake valves are a hair short on the heads. Which was causing a tick on all intake valves/rocker arms. Other than that enigne ran perfect and like I said heads are off so you're more than welcome to come inspect. Any pictures available upon request.
The intake valves are a hair short on the heads. Which was causing a tick on all intake valves/rocker arms. Other than that enigne ran perfect and like I said heads are off so you're more than welcome to come inspect. Any pictures available upon request.
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
06-13-2021 01:13 PM
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM