Sothe engine is bad in my formula and the car is not worth a new motor so everything is going up for sale. innterior is good and has 90% of the pieces. Exterior is not too great but door and hood are useable but need paint. Engine is a 305 and it has a t5 trans. Tranny is good, motor needs new bearings and an oil pump. I have a spare font bumper cover and a decklid with a spoiler. Intake has lt1 injectors and motor has an lt1 cam in it. Upper plenum has been lightly ported and throttle body has a foil in it. I also have summit block hugger headers with a flowtech y pipe, magnaflow racing cat, and a flowmaster american thunder kit. Make mean offer and let me know what you need. The exhaust was never installed but the y-pipe, cat, and headers were. let me know what you want pictures of and I will get them for you.

 

I need a manual shifter plate (the top piece of the center console) preferably with the holes for power windows and power side view mirrors. Shifter boot would be nice as well. Let me know if you've got one for me. Thanks

 

do you have the clutch and brake pedal

 

Luke, I think that I have the one you need but it may have an extra 12v socket in it if that works for you, I will take it out tomorrow and check, but it does have spots for power windows and locks, and I have a shift boot as well. makeme an offer and we can go from there and send me a zip code so I can get you a shipping quote.

Matthew, I want to avoid selling just the pedals by themselves for now in case someone wants the chasis but if the car is still here in a week they are yours. Same as with Luke make me an offer and we can go from there.

 

Do you have the power sterring/alternator bracket off the car? Its the big bracket on the driver side front of the motor
How much shipped to 38313?
thanks

 

Do have the intake duct elbow that attaches to the plenum,if so how much shipped to 60955?

 

PM sent to everyone.
I forgot to say it is a 1le brake car with a 3.43 posi disk rear end, also has ws6 suspension.

 

bump

 

How much for the carrier for the ring gear? I need a 28 spline posi unit.

 

I will only sell the whole rear end. It is a 3.43 posi with pbr calipers. 200 plus shipping.

 

How much for the whole transmission including EVERYTHING? and could you ship it to Pennsylvania?

 

If by everything you mean hydraulics then I cannot. The slave cylinder is no good but I have the clutch, flywheel, shifter, and a new starter too. 200 for tranny with shifter, clutch, and flywheel. 350 if you want the starterand i will throw in a hurst shifter.I will ship but you will have to cover any shipping costs.

 

alright i am interested in buying it all. but could you find out how much the shipping would cost? Thank you.

 

Sent you a PM

 

trans89 sorry I have been out of town for a little while and have not been able to get a shipping quote for you but I am still working on it. I should have an answer to you by thursday or friday at the latest,

 

Payment sent for heads.

 

All I have left for the car is the intake system, serpentine belt setup, 305 block and bottom end. everything else is gone or spoken for.

 

how much for the formula hood?

 

do you still have the rear end? is it a 10 bolt or the 9 bolt?