[Sold] COMP XE-268+Lifters
05-30-2012, 11:37 AM
#1
Senior Member
Thread Starter
iTrader: (15)
Join Date: Jul 2008
Location: Northeast CT
Posts: 679
Likes: 0
Received 0 Likes
on
0 Posts
Car: '89 IROC-Z
Engine: LSx
Transmission: T-56
Axle/Gears: 3.42
COMP XE-268+Lifters
I have a COMP XE-268 hydraulic flat tappet cam, specs are 268/281 advertised, 224/231 @ .050 with .477"/.480" lift using 1.5 rockers ground on a 112 lobe seperation angle. Have the matching COMP high energy lifters. These have around 3,000 miles on them and were broken in properly with cam break in lube.
A set of 16 COMP High Energy stock 7.8" length pushrods with same mileage as cam/lifters
COMP guideplates for 3/8 studs have like 30 miles on them, RHS said the heads needed them but they didnt.
$200 Shipped for all need it gone!
A set of 16 COMP High Energy stock 7.8" length pushrods with same mileage as cam/lifters
COMP guideplates for 3/8 studs have like 30 miles on them, RHS said the heads needed them but they didnt.
$200 Shipped for all need it gone!
Last edited by IROCtheThird; 10-19-2012 at 03:05 AM.
06-21-2012, 12:26 PM
#5
Member
iTrader: (2)
Join Date: Mar 2011
Location: Eastern NC
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 sport coupe
Engine: 355 sbc
Transmission: 700R4
Axle/Gears: soon 4th gen 3.23 w/ Posi
Re: COMP XE-268+Lifters
did you use any of this as a combo with the torker heads
Trending Topics
10-08-2012, 11:54 AM
#14
TGO Supporter
Re: COMP XE-268+Lifters
Hey, just saw this thread. Do you still have the cam and lifters?
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
05-17-2020 10:44 AM
no green
Engine/Drivetrain/Suspension Parts for Sale
11
01-09-2016 09:22 PM
