I've got an accumulation of parts I need gone.

Corvette 113 casting aluminum L98 heads in great shape. Came off running engine with issues at all. Come with full set of LT4 valvesprings and LT4 lightweight retainers (Not Installed) Not pictured but included are the 3/8 rocker studs and guideplates. $500.

89-92 Tpi base ported by Darin Dochterman of High Flow Fuel Injection. Darin chose to leave the runner semi rough to promote higher air velocity. Just needs a cleaning. Darin's ported stock bases outflow cast aftermarket bases and cost less, and look stock. $SOLD.

2 inch billet wheel spacers, lightly used. Price for the pair is $SOLD.

1 1/4 billet wheel spacers, lightly used. Price for the pair is $50.

1 3/8 billet wheels spacers, have a little use on them but work just fine. $40 per pair and I have two pairs of these.

Comp cams pro magnum 1.6, self aligning, 3/8 stud in great shape. $SOLD.

Crane cams gold race rockers 1.5, self-aligning, 3/8 stud in good shape as well. $175.

Cam Motion 218/218 .523/.523 112 LSA. In great shape, lightly used. Fuel pump lobe is no good but most of the cars on this site don't use it anyway. Lift is with 1.6 rockers. Cam is slightly smaller than a Hotcam. $SOLD.

Also have a 3 inch intermediate pipe for single cat cars. I believe it's stainless because it came with an SLP two on the left I had but it does slightly attract a magnet. Some stainless does have impurities in them and can attract a magnet some. My SLP loudmouth does too. It's hard to find just this part. $100.


Dynomax 4 inch bullet muffler, new with Walker/Dynomax turndown. This is for you big HP guys. $50.
Thanks for your time guys.

 

 

How much for the 113 heads without the lt4 springs retainers studs and guide plates. Just the assembled heads? Assuming still has the 1.94 intake valves size.

 

LT1,
how much do you think it would be for shipping of the 2" spacers to 40175?
Are they hub-centric for a camaro/firebird with the correct bolt pattern?

 

What is the lift of the cam without the 1.6 ratio rockers? Do you have the rpm band that it is functional in?

 

Lift with 1.5 rockers is .490/.490. Rpm powerband will be approximately 1500-5500...just a little less than an LT4 hotcam. Great for a TPI car.

 

Since the lobe separation is decent along with the durationi at 50. would it be good for a 350 tbi possibly? I dont quuite remember what duration the pcm starts going bonkers....

 

I've never had a TBI car so I can't honestly tell you much about them. I can tell you that it's great cam for a TPI car. As far as TPI cars go you can go bigger than this cam with no issues.

 

Is this cam for a factory roller block or earlier non roller block, if it is for the earlier block I'll take it

 

It's a roller cam.

 

Cam doesnt have oem stepped nose so it looks to be retrofit style for older blocks

 

My mistake I bought it as a roller cam (never looked close enough until now) but apparently the seller was incorrect. If you want it PM me as it appears it is for a non roller block.

 

I sent you a PM,, I do want the cam,, Thanks,,
Allan

 

Just sent you the payment,, thanks
Allan

 

Thanks Allan. Cam is sold guys.

 

Sold a few parts.

 

Bump.