I have parts from a 427 Dart SHP build that I lost in a fire. My 427 Super Ram was complete but never ran or installed. After inspection and testing the machine shop and engine builder tell me the block is fine just needs to go to 434. The crank is also good to go. They are not recommending reusing the rods. The block is a Dart SHP and the crank was from Eagle rotating assembly 1215600. Those 2 parts cost $2300 new, I'm looking to get $1800. I would love to sell it to someone that could finish the build I had, by using it with a super ram intake. I'm in Michigan and can help with delivery to Michigan, Ohio and Indiana. Other than that, buyer pays for shipping.
I also have a set of ceramic coated Dyno Don 1 3/4 inch headers and Y-pipe that went threw the fire. I'm asking $200 for those, they did not have any stress on them, just dirty from the fire.
Feel free to call, text or reply here with questions.
Thanks
Rich 989-670-8440

 

..... What is the bore and main size of your block ? ..... Does your block have 400 mains ? .....

 

......

 

I'd be interested in the headers. How much shipped to 08091?

Thanks!

 

It is bored to 427 but the machine shop recommends going to 434 to clean up a little rust. It can't be to bad but they generally build race motors. I'll double check but I believe they are 400 mains.

 

Headers are sold.

 

I might be interested in the crankshaft...I have a Dart Little M, and considering building a 427. It would need to have 400 mains, 2 piece RMS, forged and 4" stroke. Do you have a part # for the crank?

 

Eagle 12156000 rotating assembly. Looks like it fits your needs.