Single Plane EFI Setup
#1
Junior Member
Thread Starter
iTrader: (5)
Join Date: Jan 2009
Location: Clearwater , Florida
Posts: 70
Likes: 0
Received 4 Likes
on
3 Posts
Car: '87 Vette C4
Engine: 400 + .040 = 409 ci
Transmission: 700R4 built
Axle/Gears: Dana 44 w/3.42's
Single Plane EFI Setup
..... For Sale ... Accel Pro Ram single plane EFI base manifold ported to 1206 gasket size with a modified stock plenum adapter to make it work under the hood of a C4 Corvette ... fuel rails included ... the fuel rails have AN-8 inlet and crossover fittings with AN-6 return line fitting all fully welded ... the bottom of the plenum was milled and had a 1" billet 4bbl carb spacer welded to the bottom and the side ports welded shut ... the inlet end is ported to accept twin 58mm or Mono-blade style TPI Throttle Bodies ... by using the stock plenum , ALL factory hook-ups are maintained ... This set-up fits under the hood of my '87 vette ... The plenum adapter may not work with ANY other base intake manifold unless you install a remote thermostat housing ... $700 plus shipping ... I also have a Lingenfelter 58mm TB available to complete the package if you wish ... $300 plus shipping ... Package deal on Throttle body and intake set-up $900 plus shipping ... :thumbs: .....
Last edited by C409; 03-24-2018 at 07:23 AM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
88GTAbandit
Engine/Drivetrain/Suspension Parts for Sale
19
06-04-2019 09:55 AM
92rsvortec350
Alternative Port EFI Intakes
19
05-30-2013 12:32 PM