When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm gauging interest in the short nose B&M blower I've had sitting on the shelf for some years. I don't have the drive or idle pullies. I set this up to run off the same belt as accessory serpentine. I had BDS rebuild the drive section with new Teflon seals. I estimate it'll do about ~5psi on a stock motor. The inside of the blower has some scoring but I don't think that will affect the boost. Requires RTV to seal the blower to manifold.
Any way should be a cheap way to get some low end torque!
