I need the following:

-Lower manifold
-Runners
-ECM
-Harness
-Rails and injectors

Let me know what you got and how much thanks..

 

if its for a 305 i have injectors and rails

 

I have a base, runers, throtle body,19lb injectors,870 ecm.
$200.00 cold start tube, (no wiring, plenum or fuil rails)

 

150 plus shipping for1986throttle bodyrunnersplenumbaseserp or V-belt hardlines (your choice) but you only get one set1986 ecm 7165 ecm maf harness that needs very very minor work sorry I do not have the fuel rail or injectors from it anymore

 

jewboyxx32 how much for the injectors

 

I have the lower manifold, SLP runners and the pelnum with stock TB w/ air foil.

 

I have a complete TPI set-up from a 1985 Trans Am. Lower manifold, runners,throttle body, rails, injectors, ECM, harness, throttle cable and most of the sensors including the Mass Air Flow Sensor for $400 shipped.

 

wes how much minus the TB and plenum..? Im pretty interested.. do you have any pics??

 

I have a base/runners/injectors/rail... I dont have a complete harness though....Nor do I have a correct ECM.. I have a corvette ECM but its a little different than f-body...

If you still need these items hit me up @ nwokenwood@yahoo.com... Ill give you a good deal on them to be rid of them... They came off of my 1987 GTA..

 

I don't have pics at the moment but can take some when I get home from work in about 4-5 hours. How does $300 shipped sound?

 

If you're still interested, PM me your e-mail address.

 

Yeaa I can most likely do it.. let me know when you got pics.. sorry for the wait i was at the NHRA finals..

 

I need your e-mail address to send the pics to.

 

86camaro@sbcglobal.net

 

If interested, instead of going with a TBI setup, i have forsale a new DFI setup which is completely programable and can be tuned for any combo and modification. It comes with the complete wire harness which is new and the programable ecu (used, but works perfect). I also have up for sale a converted LT1 intake for standard sbc.
Looking to get $500 for the DFI setup and around $300 for the LT1 intake
Thanks
Tony
Located in NJ

 

Send pics of the DFI setup to the above email address.. Thanks

 

sent you a email
posting them up here also.
DFI setup and LT1 intake

 

Email with pictures sent. Let me know.

 

DFI is outta my price range but would be nice with the LT1 manifold n all.. Wes im very interested in the setup you have but i just blew a head gasket last night.. not fully but its smokin out the exhaust im gonna see if i can get a loan in the next week to buy it but if not youll have to wait until around the 1st.. let me know

 

Yeah sure.....Let me know.

 

Hi,

I have a lightly ported and polished base painted red and some nice non cold start runners also polished. I have a fuel rail with the 9th cold start injector and home made adjustable fuel pressure regulator. I also have the intake plumbing from my 89 formula. The rubber hoses from the tb to the air filter housing, as well as an air filter housing I think (I'll have to double check). I also have a used MAF that worked when I removed it but it's been sitting for awhile. I'll sell it all for $100 plus shipping.

Let me know