Looking For "NEW" Cam!!
Thread Starter
Senior Member
iTrader: (1)
Joined: Feb 2008
Posts: 805
Likes: 0
From: Waynesville ohio
Car: 1986 corvette Z51
Engine: L98
Transmission: doug nash 4+3 speed
Axle/Gears: 3:42 posi
Looking For "NEW" Cam!!
Hey guys i am looking for a new cam never ran before. This will be going in a 96 LT1 motor. I am wanting a cam bigger than the hot cam but not as big as the 306cc.
Show me what you got!
thanks
kevin
Show me what you got!
thanks
kevin
Supreme Member
iTrader: (3)
Joined: May 2008
Posts: 1,116
Likes: 1
From: boise, ID
Car: 91 B4C "police special service"
Engine: L98 494hp
Transmission: tko-600 on order
Axle/Gears: 3.23 true trac
Re: Looking For "NEW" Cam!!
try looking at the comp cams xtreme fuel series (XFI)....go to comp cams web site and check it out
Thread Starter
Senior Member
iTrader: (1)
Joined: Feb 2008
Posts: 805
Likes: 0
From: Waynesville ohio
Car: 1986 corvette Z51
Engine: L98
Transmission: doug nash 4+3 speed
Axle/Gears: 3:42 posi
Re: Looking For "NEW" Cam!!
Yes i have been looking around i thought i might find a deal where someone wants some money and to get it gone.
kevin
kevin
Supreme Member
iTrader: (3)
Joined: May 2008
Posts: 1,116
Likes: 1
From: boise, ID
Car: 91 B4C "police special service"
Engine: L98 494hp
Transmission: tko-600 on order
Axle/Gears: 3.23 true trac
Re: Looking For "NEW" Cam!!
oh....okay...I got mine off ebay for a good price new in box...check there on occasion.
Joined: Feb 2003
Posts: 1,229
Likes: 5
From: Albuquerque, NM
Car: 1966 El Camino Custom
Engine: 350
Transmission: 200R4
Axle/Gears: 3:73 12 bolt with Brute Strength
Re: Looking For "NEW" Cam!!
I have a brand new Comp Cams Custom ground hydraulic roller cam (.544 I .556 E 230 I 236E 114 lope separation). This is a custom grind I had made based off of the XFI 280. I changed directions on the motor build before I had installed this cam. I am asking $225 shipped.
Thread
Thread Starter
Forum
Replies
Last Post