[NY] flat tappet cam to run in my 327
Thread Starter
Junior Member
Joined: Apr 2010
Posts: 24
Likes: 0
From: Marion, NY
Car: 1982 Camaro Berlinetta
Engine: 327 with holley 4bbl
Transmission: T-5 WC
Axle/Gears: 3.42 non-posi
flat tappet cam to run in my 327
Looking for a cam that will run in my 327, doesn't have to be special, just want to get it back in working order is all.
Joined: Feb 2003
Posts: 1,229
Likes: 5
From: Albuquerque, NM
Car: 1966 El Camino Custom
Engine: 350
Transmission: 200R4
Axle/Gears: 3:73 12 bolt with Brute Strength
Re: flat tappet cam to run in my 327
I have one. I will look for the cam card but it's a Crane with .450 lift and 210 degrees duration at .050. Pretty mild. Lightly used. $40 shipped.
Thread Starter
Junior Member
Joined: Apr 2010
Posts: 24
Likes: 0
From: Marion, NY
Car: 1982 Camaro Berlinetta
Engine: 327 with holley 4bbl
Transmission: T-5 WC
Axle/Gears: 3.42 non-posi
Re: flat tappet cam to run in my 327
thats perfect, I will try to get it to you friday. cam card doesnt really matter much, its a crane, good enough for me. does anyone have a set of lifters or would it be ok to use used ones? I would need 3 if so.
Joined: Feb 2003
Posts: 1,229
Likes: 5
From: Albuquerque, NM
Car: 1966 El Camino Custom
Engine: 350
Transmission: 200R4
Axle/Gears: 3:73 12 bolt with Brute Strength
Re: flat tappet cam to run in my 327
PMed you my paypal address. You'll have to use new lifters or the cam will be trash in no time flat. Lifters take a set that is specific to the cam they are broken in with. I might possibly have a set. I'll look and let you know. I'm on travel but will be home on Saturday.
Thread
Thread Starter
Forum
Replies
Last Post
1988iroc350tpi
Tech / General Engine
8
Aug 14, 2015 07:52 PM