ISO: Poly motor mounts

Reply Subscribe

Thread Tools

Search this Thread

Oct 30, 2011 | 12:53 PM

Foster382

Thread Starter

Member

Joined: Jan 2010

Posts: 314

Likes: 0

From: Pasadena, TX

Car: 1991 Formula

Engine: 350TBI

Transmission: 700r4

Axle/Gears: 2.73

ISO: Poly motor mounts

looking for a pair of complete poly motor mounts; not the mount inserts.

Oct 31, 2011 | 11:06 AM

wesilva

Supreme Member

iTrader: (35)

Joined: Feb 2003

Posts: 1,229

Likes: 5

From: Albuquerque, NM

Car: 1966 El Camino Custom

Engine: 350

Transmission: 200R4

Axle/Gears: 3:73 12 bolt with Brute Strength

Re: ISO: Poly motor mounts

I wasn't aware that you could by a complete poly mount. I've only seen the inserts.

Oct 31, 2011 | 11:18 AM

Foster382

Thread Starter

Member

Joined: Jan 2010

Posts: 314

Likes: 0

From: Pasadena, TX

Car: 1991 Formula

Engine: 350TBI

Transmission: 700r4

Axle/Gears: 2.73

Re: ISO: Poly motor mounts

Quote:

Originally Posted by wesilva

I wasn't aware that you could by a complete poly mount. I've only seen the inserts.

Yeah your right, but i dont understand how i would use the inserts.

Oct 31, 2011 | 07:38 PM

wesilva

Supreme Member

iTrader: (35)

Joined: Feb 2003

Posts: 1,229

Likes: 5

From: Albuquerque, NM

Car: 1966 El Camino Custom

Engine: 350

Transmission: 200R4

Axle/Gears: 3:73 12 bolt with Brute Strength

Re: ISO: Poly motor mounts

Do you have the stock ones? If so, here is the technique I used. First I chucked up a mount in a vice. Then I took a drill and made several small holes in a pattern to where I could remove the rubber leaving just the shell. I ground down the tack welds to the shell to where I could install the inserts. Then I rewelded the shell. If anyone knows a simpler way, please share.