[OH] Lt1 t56 hydraulics needed!
Thread Starter
Junior Member
Joined: May 2010
Posts: 62
Likes: 0
From: ohio
Car: 88 camaro, 87 TA
Engine: 454 stock, built 468 400hp+150 shot
Transmission: WC t5, m29 t56 spec stg3 clutch
Axle/Gears: 9 bolt 2.77, 9 bolt 3.70
Lt1 t56 hydraulics needed!
just looking to see if any of you guys on the forum here have a master cylinder, slave cylinder and the hydraulic line off of a 93-97 lt1 t56 car. let me know how much shipped to 44721!
Joined: Jun 2004
Posts: 917
Likes: 31
From: Las Vegas
Car: '88 Trans Am
Engine: 5.7L TPI
Transmission: Slushbox
Axle/Gears: 3.27
Re: Lt1 t56 hydraulics needed!
To be honest you should spend the coin on a new set up from www.ws6store.com as per GM you should replace the hydraulics every clutch change due to actual wear and tear.
Thread Starter
Junior Member
Joined: May 2010
Posts: 62
Likes: 0
From: ohio
Car: 88 camaro, 87 TA
Engine: 454 stock, built 468 400hp+150 shot
Transmission: WC t5, m29 t56 spec stg3 clutch
Axle/Gears: 9 bolt 2.77, 9 bolt 3.70
Re: Lt1 t56 hydraulics needed!
To be honest you should spend the coin on a new set up from www.ws6store.com as per GM you should replace the hydraulics every clutch change due to actual wear and tear.
Thread
Thread Starter
Forum
Replies
Last Post
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM
