Looking for something equivalent to Hooker 2055s or the Dyno Don headers with AIR tubes. I need the AIR tubes and O2 bung intact, no holes rusted through but I'm not looking for show quality - surface rust and dents are fine. Unless you are in CO I would need them shipped to 80026.

These are just temporary for a couple years until I get my 350 built and installed; they're for a 305 so 1 5/8" primaries will work (but obviously 1 3/4" would be preferred). Thanks!

 

Look around for some Edelbrock headers. You can find people selling them on TGO from time to time. They are decent headers and are smog legal.

 

Thank you for the advice! I think I have seen references to Edelbrock p/n 68713, which looks right but doesn't seem to be available new. But if someone has a set used let me know! I'm not too picky since I don't plan to keep them long. Figured I'd buy used headers now and then pick up a quality set a few years down the road when the new engine goes in. In the meantime, I still have to pass emissions...

 

i have a set i'll part with reasonably. i can get pics after work.

 

Great! PM sent.

 

email sent.

 

Bump.

Still looking, would ideally need both the headers and the y-pipe unless I can get the y-pipe new somewhere else.

 

One last bump, still looking for a set of headers with AIR tubes and a matching y-pipe.

I'll give this another 48 hours and then it looks like I'm buying a set new.