bottom end strength
07-16-2002, 01:08 PM
#1
Member
Thread Starter
Join Date: Dec 2001
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
bottom end strength
If I was to add 10.2:1 hyp. pistons to my stock L98 bottom could it handle it? Revving will not go past 6000 rpm. The bottom end will be refreshed when putting in the pistons.
Any tips bring em on!
Any tips bring em on!
07-17-2002, 08:48 AM
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
No problem. Use ARP rod bolts in the rebuild. Resizing the big ends not a bad idea, either.
Why is this in the "Motor Swap" forum?
Why is this in the "Motor Swap" forum?
Thread
Thread Starter
Forum
Replies
Last Post
morrow
Suspension and Chassis
78
01-13-2024 12:29 PM
1Aauto
Sponsored Vendors
0
09-02-2015 01:35 PM
