lt1 & t56 driveshaft ??? Does it fit right.
Thread Starter
Junior Member
Joined: May 2001
Posts: 99
Likes: 0
From: bloomsbury,nj,USA
lt1 & t56 driveshaft ??? Does it fit right.
I'm almost done with my swap. I swaped in a 95 lt1 and t56. I put the stock 3rd gen driveshaft back in. The driveshaft can only side in to the trans about 1 inch before it bottoms out. This is with the rear axel hanging on the shocks. Is this enough?? I don't want to go killing my trans the first time I take it out
thanks
thanks
TGO Supporter
Joined: Oct 2002
Posts: 9,067
Likes: 1
From: Saskatoon, SK, Canada
Car: '83 Z28, '07 Charger SRT8
Engine: 454ci, 6.1 Hemi
Transmission: TH350, A5
Axle/Gears: 2.73 posi, 3.06 posi
Did you give the ouput shaft and driveshaft end a nice coat of gear oil?
Thread Starter
Junior Member
Joined: May 2001
Posts: 99
Likes: 0
From: bloomsbury,nj,USA
I'm not having a problem installing it. I'm just wondering if it might be too long. There is only abaout an inch of slide with it installed before the yoke would hit the tail housing of the trans.
Junior Member
Joined: Oct 2002
Posts: 72
Likes: 0
From: Felton,Delaware
It will work..
DS from 3rd to 4th all the same cept V6 4th gens
DS from 3rd to 4th all the same cept V6 4th gens
Originally posted by thatsme
I'm not having a problem installing it. I'm just wondering if it might be too long. There is only abaout an inch of slide with it installed before the yoke would hit the tail housing of the trans.
I'm not having a problem installing it. I'm just wondering if it might be too long. There is only abaout an inch of slide with it installed before the yoke would hit the tail housing of the trans.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 8, 2015 08:16 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM
