I recently killed my current setup (2 days ago) it leaned out somehow and killed a piston. I had the zz4 motor, with an upgraded valve train and some n20 and other crap. I was spraying when it went. I am looking to send the heads off have em ported, block stroked. I wanna do a 383 but I would like a proven combination. I ran a best of a 7.6@95 in the 1/8 mile with a 2.1 60'. I have stock stall in tranny, but i could replace while motor comes out (pulling motor tomorrow). I would like a parts list, proven setup. I want around the 7.6 mark without spray ( i put down 400rwhp and 430lb of tq.) with the 125 shot on that motor. I am aiming for that on just the motor then possibly spraying that. any suggestions?

 

a roller setup with good set of heads and a moderate to large cam should work.