installing engine with headers installed
Thread Starter
Senior Member
Joined: Dec 2004
Posts: 556
Likes: 0
From: my garage
Car: 84 firebird T/A
Engine: shinny 350
Transmission: slush box L65
Axle/Gears: Torsen "3.73"
installing engine with headers installed
Has anyone installed an engine in 3rd gen when it is fully assembled including headers,TPI power steering and alt?
Where do you attach the engine lifting tackle? On carburated I bolt plate to intake manifold. Can't do that on TPI.
any suggestions will be appreciated.
Where do you attach the engine lifting tackle? On carburated I bolt plate to intake manifold. Can't do that on TPI.
any suggestions will be appreciated.
Supreme Member
Joined: Oct 2000
Posts: 3,819
Likes: 3
From: Angleton, TX
Car: '92 RS
I do that every time. Engine goes in ready to go. My attachment points will be a little different, but I use the 2 rear intake mounting bolts, one of the accessory bolt holes on the front and the alternator bracket.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
