2.8MPFI to V8 carb'd wiring harness?
Thread Starter
Junior Member
iTrader: (1)
Joined: Oct 2007
Posts: 10
Likes: 0
From: Edon/Ohio
Car: 1987 Camaro
Engine: 71' 307 - holley 650
Transmission: T-5
Axle/Gears: i'll find out later...
2.8MPFI to V8 carb'd wiring harness?
Got me a 85' camaro orig a 2.8, doing a V8 carb'd swap, motors in the car, drivetrains done 
, need some help on the wiring harness.
I dont fell like doing any wiring, and a junkyard near me has 3 or 5 carb'd V8 camaros and i was wondering if i could pull the wiring harness off one of those and it plug right into my fusebrick? if not what am i going to have to do?
Thank.
PS,: where would i make a topic about my fuel lines/system?
, need some help on the wiring harness.I dont fell like doing any wiring, and a junkyard near me has 3 or 5 carb'd V8 camaros and i was wondering if i could pull the wiring harness off one of those and it plug right into my fusebrick? if not what am i going to have to do?
Thank.
PS,: where would i make a topic about my fuel lines/system?
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Welcome aboard thirdgen.org.
Hopefully you've read the V6 to V8 swap sticky https://www.thirdgen.org/forums/engi...swap-read.html . Paragraphs 4 & 10 address wiring.
Fuel lines are also addressed to some degree. Ask here if you need more detailed help.
Hopefully you've read the V6 to V8 swap sticky https://www.thirdgen.org/forums/engi...swap-read.html . Paragraphs 4 & 10 address wiring.
Fuel lines are also addressed to some degree. Ask here if you need more detailed help.
Thread
Thread Starter
Forum
Replies
Last Post
