don't come down on me too hard...
04-02-2010, 05:46 PM
#101
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2009
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 sonoma
Engine: 1985 LB9 tpi, stock
Transmission: NV3500
Axle/Gears: g80, 4.11 posi
Re: don't come down on me too hard...
ok... the engine has a nasty knock to it... i can hear it now with exhaust on it... 
i'm trying to go over everything that i need to make sure this thing is built right this time... i've got (so far) that i need an oil pump, new bearings(again), maybe a new crank, cyls honed and heads checked (i'll re-ring it and put new stem seals in it while out) anything else? i'm thinking i may get the block line honed to be sure it's straight and buy bigger bearings... should i deck the block/heads?... i'm gonna have the heads serviced too, but the machine shop wants like 1300 for all of that... i told him he was crazy...
i'm trying to go over everything that i need to make sure this thing is built right this time... i've got (so far) that i need an oil pump, new bearings(again), maybe a new crank, cyls honed and heads checked (i'll re-ring it and put new stem seals in it while out) anything else? i'm thinking i may get the block line honed to be sure it's straight and buy bigger bearings... should i deck the block/heads?... i'm gonna have the heads serviced too, but the machine shop wants like 1300 for all of that... i told him he was crazy...
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM
theshackle
Transmissions and Drivetrain
3
08-23-2015 03:49 PM
