Swap in a tpi in place of my tbi. got a 7730 ecm ADPH code and modify the chip for no vats. install everything and rewired. I get power to the injectors but the ecm will not trigger them. I crank it and the ecm will power the fuel pump. what is next to check?

 

Got it running. the tps sensor was pinned differently on my tbi then the tpi sensor. found a 4.2 volts on signal back to ecm and believe this was cuz the clear flood mode

 

anyone got a pin out of all the pins in the aldl connector? I can't connected with my scan tool yet. I know about pin m and e and have tried that. any of the connector pins to be 12 v to supply a scanner power?