Quick flex plate question
Thread Starter
Junior Member
Joined: Mar 2009
Posts: 17
Likes: 0
From: North Carolina
Car: 1986 IROC-Z
Engine: LS1
Transmission: 4L60E
Axle/Gears: 10 bolt w/ 3.73's
Quick flex plate question
Let me first say, I have searched the forum for several days looking for the answer to this question, to no avail.
I have taken out the 1 piece rear seal 305 from my 86 iroc, and I am swapping in a 2 piece seal 350. My question is, since I cant re-use my flexplate on the new motor, what flexplate do I need to get so that I can reuse my torque converter and starter.
I have taken out the 1 piece rear seal 305 from my 86 iroc, and I am swapping in a 2 piece seal 350. My question is, since I cant re-use my flexplate on the new motor, what flexplate do I need to get so that I can reuse my torque converter and starter.
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Quick flex plate question
Any 153 tooth 2 piece RMS flexplate, as long as your block is drilled for the starter.
Last edited by Apeiron; Aug 8, 2010 at 09:19 PM.
Thread Starter
Junior Member
Joined: Mar 2009
Posts: 17
Likes: 0
From: North Carolina
Car: 1986 IROC-Z
Engine: LS1
Transmission: 4L60E
Axle/Gears: 10 bolt w/ 3.73's
Re: Quick flex plate question
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
Oct 24, 2015 07:48 AM
