010 Block 350 With Street Dominator Intake, Camel Double Hump Heads, Stock Cam etc... Holly 600

Any estimates?

Not sure the casting # on the camel double hump heads but when I looked it up on a stock 305 it will push 300 Horses.

Anyway any totals? Thanks - just curious my car is almost done just waiting for the fuel pressure regulator sealant to cure

 

Which one? Details matter.

Doesn't really matter.

What DOES matter however, is the pistons. What ones of those did you use?

What prep has been done ot the heads? Are they the ones w bolt holes, or no?

Sounds like .... you'll be revisiting that... Teflon tape VERY CAREFULLY APPLIED (so that fragments can't tear off and get into the fuel stream) is the way to go

 

Stock Pistons - Flat Top ...
No Holes on the Heads just stock Camel Double Hump Heads but Will need to go get a new set of Vortec Heads apparently the Camel ones are a little warped had a small leak dribble down of coolant

 

On the intake side or the block side of the head? Either way, I'd get it fixed before running the motor. If its the intake side, its probably dripping coolant into the lifter valey which means the coolant is mixing with oil. If the block side is warped, well I shouldnt really have to say why thats bad.

 

You won't regret the vortsc heads. Waaay better than the ones you have now.

 

HP Estimate?? A bazillion hp and ten million ft pounds of torque.There without a single thing to go on,are ya happy?? I sure hope so,I did the best I could given what you gave me to work with. Certainty there are computer programs you can buy a paper dyno.Answer it's questions and it will give you some idea.But by answering those questions your going to learn a thing or two.......................