Building a Z, procharged stroker swap goodbye 305
Thread Starter
Junior Member
Joined: Sep 2011
Posts: 38
Likes: 0
Car: 1987 z28 all stock + tricked 85 z28
Engine: 388 stroker + Procharger D1SC
Transmission: TKO 600
Axle/Gears: richmond 3:73, EATON, moser shafts
Building a Z, procharged stroker swap goodbye 305
heres pics of my swap took out original 305 T5 H code drive-train 
built a 350 bored and stroked to 388, carb from the carb shop, scat forged rotating assembly, JE pistons 9:1, Procharger D1sc with 3.40 pulley on it, whiteface autometer procomp2 tach and speedo, procharger/autometer boost and fuel pressure, holley wideband A/F ratio gauge, mcleod RXT twinplate,billet flywheel, lakewood blowproof bellhousing, TKO 600, topgun driveshaft to a built 10 bolt but soon to be dana 60 from spohn, hotchkis TVS, magna fuel prostar 500 w/ boost ref -12an from tank to reg, -12 back to tank, 2x -8 to carb,
built a 350 bored and stroked to 388, carb from the carb shop, scat forged rotating assembly, JE pistons 9:1, Procharger D1sc with 3.40 pulley on it, whiteface autometer procomp2 tach and speedo, procharger/autometer boost and fuel pressure, holley wideband A/F ratio gauge, mcleod RXT twinplate,billet flywheel, lakewood blowproof bellhousing, TKO 600, topgun driveshaft to a built 10 bolt but soon to be dana 60 from spohn, hotchkis TVS, magna fuel prostar 500 w/ boost ref -12an from tank to reg, -12 back to tank, 2x -8 to carb,
Thread Starter
Junior Member
Joined: Sep 2011
Posts: 38
Likes: 0
Car: 1987 z28 all stock + tricked 85 z28
Engine: 388 stroker + Procharger D1SC
Transmission: TKO 600
Axle/Gears: richmond 3:73, EATON, moser shafts
Re: Building a Z, procharged stroker swap goodbye 305
pics
Thread Starter
Junior Member
Joined: Sep 2011
Posts: 38
Likes: 0
Car: 1987 z28 all stock + tricked 85 z28
Engine: 388 stroker + Procharger D1SC
Transmission: TKO 600
Axle/Gears: richmond 3:73, EATON, moser shafts
Re: Building a Z, procharged stroker swap goodbye 305
here
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
Oct 24, 2015 07:48 AM