This is my first post here , and my first build of a 3rd gen. Over the winter my 4th gen is getting a 408 twin turbo/ tick performance level 5 tr6060, and a crp fab 9 rear. The entire drive train , ecu, current turbo setup , wire harness and just about anything else , will be going into the 3rd gen roller I picked up. What all is involved in these swaps? I may even buy a 2nd Holley hp efi setup for the 3rd gen as well. Any guidance is appreciated. Hoping this a straightforward swap and pretty easy compared to others.

 

Check out the sticky in the LSX swap forum. It covers pretty much all the bases