Got the headers on fine, noprob... Its the Y-pipe I can't figure out... The drivers side has the donut gasket and it looks like it will fit fine.. but isn't there a gasket on the pass side? looks like somethings missing. its flat on the header side and flared on the Y pipe... looks like something should be in the middle.. also what bolts to use? bolts I have left are 4 black short bolts and 4 steel bolts 2 which are longer? same threads on both...

Thanks

 

Never mind... Figured it out... dug up the old exhaust and found the piece of crap that goes in there...

 

Let me know if your happy with these headers.

 

My87GTA, I have been very happy with my Edelbrock TES Headers, they have done a lot of my car, they are by far the best mod I have ever done.

------------------
1987 Chevy Camaro IROC-Z
L98 TPI 350 (5.7L)
TH 700R-4 Transmission with 2.77:1 Rear End

Current Mods: Edelbrock TES 1 5/8" Headers, Hooker Aerochamber Cat-Back System, Performance Resource Chip with 160* Thermostat, Accel Ignition Components, K&N Filters, All Free Mods, Falken ZIEX Z-Rated Tires.

Best ET : 14.3 @ 97mph
(corrected for elevation)