Are there any companies besides Hooker that make long tube headers for 3rd gen camaros?

 

Hedman also makes full length headers for 3rd gens, thats what I have. I have 1 5/8 primary, full length headers with a 3in. collector. I think Hedman makes other sizes also.

------------------
84 Camaro 305 ported & milled heads, 3 angle valve job, Edelbrock Performer RPM intake, Hedman full length headers, Accell ignition, Crane 274H cam, B&M 700R-4, 3000 stall speed, 4.10 gear,
M/T ET street tires
visit my website at http://www.geocities.com/jbenge/page1.html

 

How much did the Hedman headers cost you? Did you encounter any problems with the install? I like the sound of long tubes better than shorties, but want to know if I'm going to run into any major headaches.

 

I also have them, kind of a PITA to install, but worth the effort. Ground clearance is not an issue for me event though my car is dropped about 2in in front.

------------------
Black 89 IROC...Mods: 355, 10.5:1 comp, Big Solid Crower Cam, TFS heads, Victor Jr, Holley, and a 5 spd...

 

I didn't have any major problems on the installation of mine. But I don't have A.C. or emmissions equipment so that makes it a lot easier. I have plenty of ground clearance, just be sure to route the y-pipe well and you won't have any problems. I don't remember for sure how much my headers cost, its been awhile maybe $300-350. They were expensive because I got them coated, you will have to call jegs or summit for a price.

------------------
84 Camaro 305 ported & milled heads, 3 angle valve job, Edelbrock Performer RPM intake, Hedman full length headers, Accell ignition, Crane 274H cam, B&M 700R-4, 3000 stall speed, 4.10 gear,
M/T ET street tires
visit my website at http://www.geocities.com/jbenge/page1.html

 

Thanks guys. Should be about what I expected for the install. I have A/C but no emissions eqipment. I was just curious, because one of the footnotes on the Jegs site said the install required floorpan mods. Didn't want em if that was the case.