well its pretty new, not rusted, it was put on with clamps, how do i pull the pieces apart, they rotate, but cant get them out


------------------
Trent
---Car---
89 Firebird/305 L03 TBI A4/t-tops
Open Element Edelbrock Aircleaner w/ K&N air filter/Summit Chrome Valve Covers
---Stero---
Pioneer DEH-P730 Premium
Infinity 2way 4652 4x6's/Pioneer 4way ts-a6985 6x9's
profile cl640 110x4
----Comming in a few days----
Edelbrock TES headers 3" out/flowmaster American thunder 3" exaust/Catco HighFlow catco cat

 

I just had to do that when I put my headers on. What I did was just keep rotating them and pulling at the same time (very tiring) and spray a bunch of WD-40 up in the connection to provide a little lubrication. Eventually they should come free. It'll just take some work.

Matt

------------------
irocet@hotmail.com

drive.to/Stang_Kilr

88 IROC-Z -- 350 L-98, 700R4, Flowmaster, Edelbrock Headers, Catco Cat, K&N, MAF Sceens Removed, Airfoil, March Pullies, Comp Cams Magnum 1.6 Roller Rockers, Bosch Platinum Plugs, Accel 8.8 mm Wires, MSD 6AL, Hypertech Cap & Coil, Hypertech Chip, Hotchkis Strut Tower Brace

 

ok, is ot ok to hammer on the muffeler, like with a wooden block, or will that break something

------------------
Trent
---Car---
89 Firebird/305 L03 TBI A4/t-tops
Open Element Edelbrock Aircleaner w/ K&N air filter/Summit Chrome Valve Covers
---Stero---
Pioneer DEH-P730 Premium
Infinity 2way 4652 4x6's/Pioneer 4way ts-a6985 6x9's
profile cl640 110x4
----Comming in a few days----
Edelbrock TES headers 3" out/flowmaster American thunder 3" exaust/Catco HighFlow catco cat

 

If it is a Flowmaster muffler, you could probably bang it a little bit, but I wouldn't be hitting too hard or too much. All that is inside a Flowmaster muffler are welded in plates to direct flow and sound. Question: Why do you need to bang on the muffler anyway? Just curious.

Matt

------------------
irocet@hotmail.com

drive.to/Stang_Kilr

88 IROC-Z -- 350 L-98, 700R4, Flowmaster, Edelbrock Headers, Catco Cat, K&N, MAF Sceens Removed, Airfoil, March Pullies, Comp Cams Magnum 1.6 Roller Rockers, Bosch Platinum Plugs, Accel 8.8 mm Wires, MSD 6AL, Hypertech Cap & Coil, Hypertech Chip, Hotchkis Strut Tower Brace

 

cut some expansion slits in the pipe with a cut off wheel.

------------------
90 IROC
SuperRamed 406
Trickflow 23* heads