These Header any good??
Thread Starter
Senior Member
Joined: Dec 2001
Posts: 734
Likes: 0
From: Seattle, Washington, United States
Car: 1986 Trans Am WS6
Engine: Mild 350 TPI
Transmission: 700R4
These Header any good??
I have been looking at getting headers and came across these in the summitracing catolog. Edelbrock Headers Would these be good? I am on a low low budget since i only make $7.11 an hour! 
Joined: Mar 2000
Posts: 43,187
Likes: 42
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Probably the most common 3rd gen header out there.
CHP's "My Generation Camaro" 350 made respectible dyno power with a set of those installed (no cat, just a 3" muffler where the cat goes).
CHP's "My Generation Camaro" 350 made respectible dyno power with a set of those installed (no cat, just a 3" muffler where the cat goes).
Supreme Member
Joined: Jan 2003
Posts: 2,067
Likes: 1
i have a q about those headers. i got 'em on my car and the part of the primaries where they join at the collector decreases in size and has a "flattened" shape. i'm guessin this has to create a restriction in each pipe, but are all headers like this or is it just this brand? it probably doesn't even matter unless we're talkin about on a high HP motor.
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] 1 3/4 budget LS swap headers NEW (CA)
topteam54
LSX and LTX Parts
10
Aug 11, 2015 07:15 PM