The time has come to upgrade my motor, the heads I have are protopline 180cc angle plug heads, is anyone out there running hooker 2055s with these heads or any angle plug heads??? And if they won't fit what headers will? Just curious if I'm gonna run into fitment problem. Thanks

 

I'm using corvette L98 angle plug heads and 2055's they fit fine.

 

Cool, thanks. I'm sure mine will fit fine, unless there is a difference between a factory casting and an aftermarket casting. Probably not though. Anyone out there running these headers with aftermarket angle plug heads, can you verify this to set my mind at ease?

 

There is a difference between the L98 angle plug heads and standard angle plugs heads, so be careful.

 

Im running a set of dart angle plug heads and the 2055's. The only problem i had was the 3rd plug back on the passenger side the one right in front of the dipstick. Its hard to work with not much room. If the dip stick wasnt there i wouldnt have had any problems. Also i dont know what type of spark plug wires your are running but i found that all 90* deg boots work great and are easy to keep away from the headers.

 

Cool, Thanks btw, I was running all 90 degree boots with the 2055s on the stock longblock, so i figured i would have to with the new motor too. Thanks again for putting my mind at ease