anyone have this on your car? got any sound clips? i'd love to hear a setup with some headers (LT or shorty), 3" pipe all the way back to one mounted in the stock location...anyone got one?

Josh

 

Ive ran dual super 40's with 3 inch pipes. They were awesome sounding mufflers but since they had such a large case and I had them mounted underneath I had absolutely no ground clearance!

 

yea, i had forgotten how big the case of those suckers are! i still think i'll run 'em though...don't know if i'll do duals or not...think i might run just single 3" pipe back to one Super 40...i dunno though

Josh

 

Sorry no sound clip but, am running shorties & 3" y-pipe - pipe all the way out to a single inlet, dual 3" outlet, Flowmaster 40 set up on my IROC. Not as throaty as I was hoping... LT's might have made a difference but, clearance is an issue for me so it's okay.

 

is it the standard 40 or the Super 40, there is a difference and that might be your "deep" issue...

Josh

 

wat would be the loudest sound that i could get for my 305?? its all stock but i want something effin loud if u know wat i mean..would the flowmaster 40 be the way to go...(super 40 i like a little better)??? help me out...how bout borla mufflers or MAC or any of those expensive ones??? I JUST WANT LOUD!!!!!!!!!!!!!!!!!!!!!!!!

 

well, i want it pretty loud too...and every Flowmaster Super 40 i've seen has been LOUD. that or the SLP loudmouth mufflers are about the loudest you can get...you might also wanna check out V-Force...i might even go this route but i dunno, i like the Super 40s...wish someone had a sound clip...just remember performance when you do the exhaust...you are gonna want headers...WELCOME TO THE SITE!!

Josh

http://www.flopro.com/VForce.htm

 

Want loud? get a flowmaster sgl chamber race muffler. I run one 3-1/2 inch ctr inlet/outlet in the stock location. Its loud.
The system is shorty headers(SLP) with a custom Y-pipe made from a Flowmaster dual 2-1/2->sgl3-1/2 outlet Y-collector that merges into a 3-1/2 "I" pipe that goes up and over the axle to the Muffler in the stock location. No CATS.

 

so right now i have a 2.5 inch exhaust going into a 80 series flowmaster muffler and dual existing 2.5 inch pipes......and how much would this sgl muffler cost me???
----------
i ment to say exiting tail pipes..also is that like a clean sound or is it raspy or wats it sound like...can i get a sound clip?

 

oh RWB, THANK YOU! you have introduced me to Flowmaster's RACE line...i never even noticed it was on the site until you mentioned it and i went looking...looks like the muffler my Camaro's getting is the Flowmaster 40 Series Delta Flow Race muffler...check THIS sound out!

http://www.flowmastermufflers.com/40_race.html

Josh