JEGS catback
Thread Starter
Member
Joined: Sep 2003
Posts: 260
Likes: 1
Car: -88 TA GTA
Engine: 350 tpi
Transmission: TH700
Junior Member
iTrader: (1)
Joined: Sep 2006
Posts: 43
Likes: 0
Car: 1984 Z28
Engine: L69
Transmission: 700R4
Axle/Gears: 3.73
Re: JEGS catback
I installed this Jegs catback kit on my 84 L69 Z about 6 months ago when I first got my car and needed a quick pipe/muffler replacement. Install was pretty straightforward although the over axle pipe vibrates against the rear chassis brace above the panhard bar. (You have to lower the chassis brace to get the pipe over the axle.) Part quality seemed pretty good for a relatively low cost set up. I also had to trim the tailpipes to even out the length. It's quieter than I expected.
Hope this helps.
Mike
Hope this helps.
Mike
Member
Joined: Oct 2006
Posts: 364
Likes: 2
From: Charlotte NC
Car: 1991 Camaro RS
Engine: The Wicked six'ah
Transmission: 700r4
Axle/Gears: stock 3.08's
Re: JEGS catback
Get the 16823 I did, My MPG went down, Cause I drive in 3rd gear everywhere to hear that Awesome rumble.... its perfect. (I Believe so)
Thread
Thread Starter
Forum
Replies
Last Post





