How do i reroute the exhaust for my SFConnectors?
Thread Starter
Member
Joined: Nov 2001
Posts: 333
Likes: 0
From: albuquerque
Car: 1992 Z28
Engine: 350 L98 w/ D-1SC
Transmission: POS 700-R4
How do i reroute the exhaust for my SFConnectors?
Ordered comp. engineering SFC's and my cats are in the way on the passenger side. How can I make this work?
Supreme Member
Joined: Jul 2000
Posts: 1,341
Likes: 0
From: Where the chicks absolutely LOVE the V-8 rumble!
Car: 92 RS - Fully Restored w/Custom Int
Engine: LO3 with some mods
Transmission: T-5
Axle/Gears: 3.42 Richmond
Either you adjust the exhaust by loosening, moving, and re-tightening the connections.
OR
Buy modified SFC's for this specific purpose.
ONE THOUSAND POSTS!!!
OR
Buy modified SFC's for this specific purpose.
ONE THOUSAND POSTS!!!
nly connectors i ever found that will clear are the jegster bolt-ins from jegs. 
Senior Member
Joined: Mar 2002
Posts: 586
Likes: 0
From: fairborn, ohio
i run them
i use them.....fits tight up against the floor board and the passenger side follows the contour of the floor pan to go over top of the cat area. i would definately recomend them. they prove excellen support and will give a good foundation for drive shaft loop and ladder bar x-members when you weld them in.
Rich
Rich
Thread
Thread Starter
Forum
Replies
Last Post
david068513
Camaros for Sale
0
Sep 18, 2015 10:36 AM
gta892000
Cooling
6
Sep 16, 2015 12:37 AM