Just like title says. Looking for parts to be in good shape. Plastics should be within 2 hour driving distance from Hatboro, Pa 19040

 

Hawks sells a reproduction middle console lid now.

 

I have a complete tan interior out of an 88 Camaro. Different tan from 84 though. I am located Long Island, NY.

 

Have a almost complete tan interior out of 91 GTA

But i'm in Oklahoma, So shipping would have be involved !!


Dave

 

Hawks sells a perfect 82-84 Firebird console lid.

http://www.hawksmotorsports.com/1982...-reproduction/

 

Yeah Oklahoma is way to far and yes I am awarr Hawk's has them wasn't trying to spend that much just yet. I was hoping somebody mind havevone laying around.

 

You must understand, You're looking for RARE $$$ parts that also have a HIGH DEMAND from the Knight rider crowd


You might find someone on craigslist that has these parts "laying around" but it might take a LONGGGG TIME !!!

Good luck on your search

Dave

 

Did u check out www.thirdgenranch.com?

 

I have console lid out of a 87 TA if that works and I am near West chester PA. I'll check to see what rear plastics I have also.

 

He needs a 82-84 style Square lid,
85-92 lids will not work on those consoles

best bet is Hawks third gen, they make them new reproduction, not cheap but not many choices on that style lid, even on eBay they go for big money used


dave

 

Thanks for the offer but that console it is different than mine

 

Keep in mind what Mikes86SC just said,....

Be care full what you buy because some folks don' know there are more than 1 shade of "tan" and might sell you the wrong parts .



The picture above shows the underside of a door sill from - WHAT I BELIEVE to be - an 86 Z28 with the early shade of "tan" interior color. Above it you can see part of a "tan" interior panel from a 91 Z28. CLEARLY these 2 shades of tan are not the same.

If you've already got old "tan" interior parts that you need to replace I would check the backside of each panel you need to replace to see what the "REV #" is. Buying replacement parts with the same "REV#" might help you to avoid buying the wrong shade of "tan". ( Don't depend on a picture - kinda' hard to judge when only 1 tan shade is shown at a time )

P.S. I've got a couple early "tan" interior panels too....... but I'm a bit more than 2-hours drive from PA and the parts are only DD quality - not the highest quality and therefore not worthy of justifying the shipping expense.

Hope this helps !