Heads up display conversion?
Thread Starter
Senior Member
Joined: Jun 2003
Posts: 828
Likes: 3
From: Rockville, MD
Car: 1989 Camaro RS
Engine: Ellis Juan
Transmission: t-56
Heads up display conversion?
Joined: Jun 2006
Posts: 254
Likes: 1
From: South Dakota
Car: 1990 Camaro RS
Engine: 305 TBI (LO3)
Transmission: T-5
Axle/Gears: 3.08
Besides the obvious wiring issues.. You would also have to put the unit recessed in the dash and put a special windshield reflector "Thingy" for lack of better words, to show the HUD Display. Never seen it done before but I'll be sure to tell you nothing is impossible.
i've seen something similar fabbed up on a fiero on the net before. But it didn't use a factory HUD. Just used a 7-segment LED display and had it show the numbers' mirror image and then that reflected on the windshield. It was for a digital tach. The hard part was designing the tach circuit.
Thread
Thread Starter
Forum
Replies
Last Post
two-if-by-sea
Problems / Help / Suggestions / Comments
1
Aug 31, 2015 06:30 PM
