Steering column removal
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 57
Likes: 0
From: Tucson, AZ
Car: 91 Camaro
Transmission: 700 r4
Axle/Gears: stock, soon to change.
Steering column removal
hi, im installing a new steering column due to vandals..
its a 91 Camaro.. is there any tricks or anything i'll have to do to get the old column out??
thanks!
its a 91 Camaro.. is there any tricks or anything i'll have to do to get the old column out??
thanks!
Supreme Member
iTrader: (12)
Joined: Feb 2006
Posts: 1,326
Likes: 2
From: Massillon, Ohio
Car: 87 TA
Engine: 350
Transmission: 700r4
Axle/Gears: 2.73
Re: Steering column removal
no tricks, it's pretty straight forward. once unbolted it should just slide rightout. If you have an airbag make sure to pull the fuse and carfully remove it from the steering wheel first. you don't want that going off in your face.
good luck 
Joined: Sep 2000
Posts: 1,153
Likes: 18
From: Annapolis Maryland
Car: To many to list
Re: Steering column removal
Dont forget about your VATS system though.The new column probably wont be the same resistance so you will have to address that.As far as removal,1 15mm nut in the engine bay on the steering shaft,3 10mm holding it to the firewall and 2 13mm holding it the the dash.Then there area bunch of plugs and the shifter cable.Not a bad job at all.
Thread
Thread Starter
Forum
Replies
Last Post