Pro ratchet using megashifter console trim?
Thread Starter
Supreme Member
iTrader: (8)
Joined: Jul 2001
Posts: 3,204
Likes: 7
From: New Boston, IL, USA
Car: '90 Formula 350
Engine: 383 SBC
Transmission: ProBuilt S/S 700-R4 & ACT 9" Stall
Axle/Gears: 10 bolt 3.23
Pro ratchet using megashifter console trim?
Has anyone ever tried to use the megashifter console trim [overlay, boot, gear indicator] on a pro ratchet shifter?
I'm thinking about giving it a shot. I've already had to hack apart my console plate [formula curved ash tray hit the shifter] and some bracing to get the pro ratchet to fit. So I need to get a piece of aluminum or steel to make a new top plate anyways.
I have the old console pieces for the megashifter boxed up in the garage somewhere. I'm wondering if the gear indicator from the megashifter would work off the pro ratchet red arrow indicator. That way I could just bolt it all back together and have a nice looking flush install.
I'm thinking about giving it a shot. I've already had to hack apart my console plate [formula curved ash tray hit the shifter] and some bracing to get the pro ratchet to fit. So I need to get a piece of aluminum or steel to make a new top plate anyways.
I have the old console pieces for the megashifter boxed up in the garage somewhere. I'm wondering if the gear indicator from the megashifter would work off the pro ratchet red arrow indicator. That way I could just bolt it all back together and have a nice looking flush install.
Thread
Thread Starter
Forum
Replies
Last Post
