Did a redo on my door panel with black Alcantara and charcoal grey piping. It's padded up a bit so it's nice an plush. Just need to touch up the top right corner with a bit of SEM and it'll be good to go.

 

Nice job!

 

Awesome.

 

Nice work,...... Looks like you've got some Q-Forms kicks in that ride too, a great way too customize your interior !

 

Thanks. Those aren't Q-Form. I made those back in 2009 out of my own factory kick panels and a t-shirt. Wasn't a bad project to do. They've been recovered since in a nicer vinyl.

https://www.thirdgen.org/forums/car-...empt-kick.html

 

Those look really good!
The side mirrors the rare paddle mirrors??

 

Yes, those are factory DD9 mirrors.

 

Love the way your door panels turned out.

Always wanted to do a set of the one piece molded door panels in Beechwood Tan like you did yours with a set of these seat covers but in leather.




1985-1992 Trans Am GTA seat Covers In Correct Beechwood Tan w/Black | eBay

 

Would love to see those installed.

 

Any tips on how you did it? You know something like a quick diy post on how you recovered them?

 

The entire black section is on a 1/8 inch piece of plywood. The plywood is fastened to the door using those fir tree panel clips. So a few holes were drilled to accomodate them. I had a local upholsterer wrap the plywood with a little foam to give it some dimension, and Alcantara and the grey piping.