what is everyone doing 4 the steam line? i read alot of pple just drill the top of the water pump or the upper radiotor hose. how does that work, how come its now spraying coolant everywhere?

 

I have a line running from my steam outlet on the heads to the bung on the rad that a heater hose used to connect to. Going to switch to an LS1 rad and run it back to where the original LS1's ran to.

 

I swapped my 3rd gen radiator for a 4th gen, and just ran the hose normally.

 

Mine's ran right in to the top of the waterpump as shown in my write up pics.

 

LT1 or LS1? Both have a steam line, and in two totally different places...

 

i dont under stand why it doesnt spray out, if i decide to drill the water pump?

 

Have you even looked at the pictures or writeup?

 

i understand now. im a big dummy. dont have the motor yet, didnt realized both side r hooked up

 

can some one fill me in please? I didn't find anything in the tec articals and im introseted in learing more so help me!

 

I don't know if you checked the sticky for this section... Here's a link. Just bring that up and hit Ctrl+F and type in the word steam and press enter (IE7 anyway). Should take you right to it...

Also, Aaron91RS has a page about it in his write-up. Here's the link.

Hope that helps. Good luck!

 

heres mine, zoom in on the text if ya cant read it..