Well i got my kit and have a question before I instal it. My plans were to put the bottle in the rear compartment of the T/A (in the hole), and as I was eyeing up the situation, i noticed if I drill the hole for the main feed line straight down. the line will be awfully close to the exhaust. Should i run the line inside the car untill just after the wheel well, and then through the floor and along the fuel lines? Whats the best way to do it???

 

I did it through my interior, following the center console.

 

Mine came out just above the gas tank heat shield. I ran it along the inside edge of the heat shield to the fuel lines I ran the car until it was hot and felt the line and it wasn't hot. So all is good. Just for added safety I might install a piece of heat shield hose on the line there.

Btw, I saw your post over on Macs board. Didn't get a chance to answer it.

 

On my 91z i ran it on the pass. side of the car(inside) under the sill plate and behind the kick panel(there is a wiring bulkhead). I took my time and drilled a hole through the bulkhead(the wires were in the middle w/alot of room to the top and bottom). Took me forever, coz im a wuss and didn't want to nick a wire, but finally i got it through there and then it goes behind the fender and into the engine compartment. Later Derrick

 

Oh and i forgot to tell why I did it this way 1)the nos line is protected by the elements and 2)i didn't want to drill a hole in my body...Later guys Derrick

 

Right on guys!! Thanks for the help...