Turbo tubes in place
03-16-2009, 12:28 PM
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2008
Location: NE Ohio
Posts: 751
Likes: 0
Received 2 Likes
on
2 Posts
Car: 82 Z28
Engine: TT LS
Transmission: 4L80E
Axle/Gears: S60 3.54's
Turbo tubes in place
The hot side tubing is 5" and the compressor side pipes are 4". Most of it was quite easy actually
The new radiator location about 6" forward and 6" down
The water pump for my motor. I just used some sheet metal to make a housing around an electric pump that fits an LT1.
And some roll cage bars tacked in place
The new radiator location about 6" forward and 6" down
The water pump for my motor. I just used some sheet metal to make a housing around an electric pump that fits an LT1.
And some roll cage bars tacked in place
03-16-2009, 06:50 PM
#2
Senior Member
iTrader: (1)
Join Date: Dec 2000
Location: chicago
Posts: 689
Likes: 0
Received 0 Likes
on
0 Posts
Re: Turbo tubes in place
looking good. on my setup my downpipe has been reduced to 4" and it will dump where the cats were. i see your running an a/w setup , i opt for a/a for its simplicity. how did u run the crossover???
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
09-28-2015 12:35 AM