Ok, I order to go from my 2.77 to 3.27's, I am going to need the pinion, ring gear, and carrier correct? Anything else that I'll need?

This is what I got so far:




Thanks!

 

are those caps from your rear or a different? they are all different and specific to each individual rear, as well a left and right. do not mix them up or you will be f-ed.

if the 3.27 requires a different carrier, then yes, all you need is the gears and the new carrier, unless you get a new set of gears, then you can get a gear set already set up for whatever carrier you already have. new bearing are also a good idea. you can use your old yoke, the splines are the same for all 7.5 10 bolts.

you also need the appropriate speedo correction gears.

 

Thanks! Everything in that picture is from a 3.27 rear. Looks like all I need is the carrier and ring gear from that rear end.

 

like i said, use your bearing caps, dont use the ones from the other rear.

 

Will do, thanks again. It is appreciated.

 

If I'm not mistaken, ring and pinion gears are matched sets which are lapped together. You can not mix non matching part without something bad happening.

 

you are corrrect