Broken Drivers Seat
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Grab a seat from the yard and I will transfer the cover for you.
Supreme Member
iTrader: (1)
Joined: Dec 2004
Posts: 2,492
Likes: 0
From: Arcadia ,Ca
Car: 82 firebird s/e 83 Trans Am
Engine: 5.0L 305ci 4b carb.....CFI
Transmission: TH200C....700R4
Just pull a new lever off a good seat at the junkyard and screw it into your seat.I had the same problem and thats what I did .Its like putting legos together
Thread Starter
Supreme Member
Joined: Aug 2002
Posts: 1,413
Likes: 0
From: San Pedro, Ca
Car: White KSwisses
Engine: 5.3L Gen III
Originally posted by 82knightrider
Just pull a new lever off a good seat at the junkyard and screw it into your seat.I had the same problem and thats what I did .Its like putting legos together
Just pull a new lever off a good seat at the junkyard and screw it into your seat.I had the same problem and thats what I did .Its like putting legos together
Trending Topics
Supreme Member
Joined: Dec 2001
Posts: 1,411
Likes: 0
I had to replace a lever in my drivers seat in my Malibu once.. After I spent the big bucks for a new lever the seat completely broke a few adjustments later..
Don does a great Job with the cover swap.. I watched him swap the cover once.. I never knew it was possible.. I could have had a few covers in my color if I had known.. Now the seats are harder to find.. Esp. when your not out looking.. Like me.. Have not been to a pyp in a long time..
Don does a great Job with the cover swap.. I watched him swap the cover once.. I never knew it was possible.. I could have had a few covers in my color if I had known.. Now the seats are harder to find.. Esp. when your not out looking.. Like me.. Have not been to a pyp in a long time..
Member
Joined: Jun 2005
Posts: 409
Likes: 0
From: desert
Car: only GM,88 camaro, 91r/s camaro, 91
Engine: Clean oil, looks fresh, no leaks
Transmission: Bright Red, never burnt, no leaks
Axle/Gears: currently whining
hi all . amd dyno don,,,, im up here near palm springs, in yucca valley, i was wondering !, my drivers seat is riped pretty bad on the edge where i get in at,, how much would it be to have it fixed or recovered?? thanks...................
Joined: Jul 1999
Posts: 10,950
Likes: 26
From: Orange, SoCal
Car: 1990 Pontiac Trans Am
Engine: 355 TPI siamesed runners
Transmission: Tremec T56
Axle/Gears: 12-Bolt 3.73
Yahoo Yellow Pages:
http://yp.yahoo.com/
Put in your address and then search for upholstery shops. You'll find someone local to you.
http://yp.yahoo.com/
Put in your address and then search for upholstery shops. You'll find someone local to you.
Guest
Posts: n/a
Usually with people like me, Ken, Mike... its the frame of the seat itself thats broken. It'll be about halfway up, split in two. Car accidents will do this damage too with lighter people. I have seen the holes tear on the lower frame as well, so... go to a junkyard, find a seat that looks good, take the cover off right there in the yard so you can inspect it, and buy it if its ok.
Member
iTrader: (2)
Joined: May 2003
Posts: 362
Likes: 1
From: bakersfield, ca
Car: 92 B4C/1LE CHP camaro 06 vette LS2,
Transmission: iroc, 700r4, auto
if you need a new track or frame i have a few of them available. you would have to come to bakersfield to pull from the car and dismantle them. email is ron09517@aol.com
Thread
Thread Starter
Forum
Replies
Last Post
Mister_Johnny99
Interior Parts Wanted
0
Aug 14, 2015 12:59 PM