Help me put everything together!
Thread Starter
Senior Member
iTrader: (1)
Joined: Feb 2008
Posts: 805
Likes: 0
From: Waynesville ohio
Car: 1986 corvette Z51
Engine: L98
Transmission: doug nash 4+3 speed
Axle/Gears: 3:42 posi
Help me put everything together!
Ok i want my car to handel very good! I want it to go around turns like it never has. I want to do all of it at once pretty much.
So heres what i thought of.
kevin
So heres what i thought of.
- Springs
- Shocks
- sway bar kit
- wonder bar
- tires
- Ok the springs i think i would like to drop it no lower than an inch.
- The shocks i want to get one of the best.
- Sway bar kit i dont know tell me the one the best.
- Wonder bar i seen them on ebay.
- Then tires i am thinking of radial TA's but i dont know what they are rated to. Then the crapy tires right now i have are 235/60/15 and when i go around a turn to fast you can fell them buckle. So i want a tire rated around 150 mph then that will help me wip around a turn.
kevin
Supreme Member
iTrader: (5)
Joined: Aug 2007
Posts: 1,525
Likes: 1
From: Milwaukee, Wisconsin
Car: 1987 IROC-Z
Engine: 383 with Edelbrock ProFlow EFI
Transmission: TH350
Axle/Gears: 12 bolt 3.73 Eaton posi
Re: Help me put everything together!
I would suggest getting the Eibach Pro-Kit (drops 1in. front and rear) and the Koni Yellows from shox.com. The seem to have the best deal if you buy thier package deal. For sway bars, just get a 36mm hollow front bar and a 22mm solid rear bar. They are factory pieces so they are a lot cheaper than aftermarket and they are readily available. I say 22mm for the rear and not the 24 because the 24 makes the back a little loose. For t3he3 wonderbar, once again, just get a factory piece. They are plenty strong enough, readiliy available and a lot cheaper than a aftermarket part. I'm not very good in the tire department. Someone else will have to chime in here. I plan on getting a set of BFG G-Force tires for my 16" IROC wheels but I don't know what would be best for your 15" wheels.
Mike
PS - Have you considered changing for stock worn out rubber bushings for some Poly bushings? That alone will amke a big differance.
Mike
PS - Have you considered changing for stock worn out rubber bushings for some Poly bushings? That alone will amke a big differance.
Thread
Thread Starter
Forum
Replies
Last Post




