Problem after replacing tie rods and center link.
05-07-2013, 07:12 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2012
Location: Camp Lejeune, NC
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Z28
Engine: 355
Transmission: 700R4
Problem after replacing tie rods and center link.
I just got done replacing my tie rods and center link. At close to full turn in either direction it feels bumpy. Will a professional alignment resolve this or is it something else?
05-08-2013, 12:12 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,650
Likes: 0
Received 44 Likes
on
42 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Problem after replacing tie rods and center link.
It needs an alignment since you replaced those parts. Get one and see if it goes away.
Don't use the factory alignment specs, they suck. There are better ones in the stickies
Don't use the factory alignment specs, they suck. There are better ones in the stickies
05-08-2013, 05:06 PM
#3
Junior Member
Thread Starter
Join Date: Oct 2012
Location: Camp Lejeune, NC
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Z28
Engine: 355
Transmission: 700R4
Re: Problem after replacing tie rods and center link.
Just got back from the shop. Problem solved. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
15
12-29-2023 08:23 AM
